Front Brake Disc Replacement

Front Brake Disc Replacement

NOTE: Keep grease away from the brake disc and the brake pads.

1. Raise and support the vehicle Service and Repair.

2. Remove the front wheel.

3. Remove the brake hose mounting bolt (A).





4. Remove the brake caliper bracket mounting bolts (B), then remove the caliper assembly (C) from the knuckle. To prevent damage to the caliper assembly or the brake hose, use a short piece of wire to hang the caliper assembly from the undercarriage. Do not twist the brake hose excessively.

5. Remove the brake disc flathead screws (A).





6. Remove the brake disc (B) from the hub.

NOTE: If the brake disc is stuck to the hub, screw two 8 x 1.25 mm bolts (C) into the brake disc to push it away from the hub. Turn each bolt 90 degrees a time to prevent the brake disc from binding.

7. Install the brake disc in the reverse order of removal.

NOTE: Before installing the brake disc, clean the mating surfaces between the hub and the inside of the brake disc.

8. Inspect the brake disc runout.

9. Clean the mating surfaces between the brake disc and the inside of the wheel, then install the front wheel.