B1187

DTC Troubleshooting: B1187

DTC B1187:

Gauge Control Module Lost Communication With SRS Unit (SRS Messages)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0), and then back to ON (II).

3. Start and run the engine for at least 5 seconds then turn the engine off.

4. Check for DTCs with the HDS.

Is DTC B1187 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the F-CAN communication line is OK at this time. Check for the DTCs in the SRS with the HDS. If F-CAN DTCs are present, check for loose or poor connections at the gauge control module and the SRS unit. If the connections are good, check the battery condition Testing and Inspection and the charging system, then clear all DTCs.�

5. Check for DTCs in the SRS with the HDS.

Are any DTCs indicated?

YES -

Go to the SRS indicated DTCs troubleshooting.�

NO -

Go to step 6.

6. Do the gauge control module input test Gauge Control Module Input Test.

Are all inputs OK?

YES -

Go to step 7.

NO -

Repair the faulty input, then recheck the DTCs.�

7. Substitute a known-good gauge control module.

8. Clear the DTCs with the HDS.

9. Turn the ignition switch to LOCK (0), and then back to ON (II).

10. Start and run the engine for at least 5 seconds then turn the engine off.

11. Check for DTCs with the HDS.

Is DTC B1187 indicated?

YES -

Substitute a known-good SRS unit and retest. If the symptom/indication goes away, replace the original SRS unit.�

NO -

The original gauge control module is faulty; replace it Service and Repair.�