Programming and Relearning

Immobilizer Key Registration

NOTE:

- The HDS is required for registration of the immobilizer keys.
- Check for aftermarket electrical equipment that can cause problems with transponder operation.
- The immobilizer control unit-receiver can store up to six immobilizer Keys.

Add one new key

1. Have a registered key, a new immobilizer key cut to fit the ignition switch, and the first password from the iN system.

2. Connect the HDS to the data link connector.

3. Turn the ignition switch to ON (II).

4. Select IMMOBI from the IMMOBILIZER SETUP menu.

5. Select "Add and Delete Keys", then "Add 1 key".

6. Do the registration according to the instruction of the HDS screen.

7. Check if the engine can be started by the newly registered key.

Delete or add multiple keys

NOTE: If any of the registered keys were lost, do the following procedure to delete the lost registered key.

1. Have all registered keys, all new keys, and the first password from the iN system.

2. Connect the HDS to the data link connector.

3. Turn the ignition switch to ON (II).

4. Select IMMOBI from the IMMOBILIZER SETUP menu.

5. Select "Add and Delete Keys", or "Delete or Add Multiple Keys".

6. Do the registration according to the instruction of the HDS screen.

7. Check if the engine can be started by all the registered keys.

All keys are lost

1. Prepare all new keys and have the immobilizer PCM code from the iN system.

2. Connect the HDS to the data link connector.

3. Turn the ignition switch to ON (II).

4. Select IMMOBI from the IMMOBILIZER SETUP menu.

5. Select "Add and Delete Keys", then "ALL KEYS LOST".

6. Do the registration according to the instruction of the HDS screen.

7. Check if the engine can be started by all the registered keys.