License Plate Frame: Service and Repair

Rear License Trim Replacement

'08-10 Models

NOTE:

- Take care not to scratch the tailgate.
- Put on gloves to protect your hands.

1. Remove the tailgate lower trim panel .

2. Remove the bolt securing the rear license trim. With navigation system: Disconnect the rear camera unit connector (A), and detach it from the tailgate.






3. Remove the rear license trim (A).

1. Open the tailgate.

2. From inside the tailgate, detach the clips (B, C).

3. Gently close the tailgate.

4. Release the harness grommet (D) from the body, then pull out the rear camera unit subharness (E).





4. Install the trim in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the rear camera unit subharness connector is plugged in properly.
- Make sure the harness grommet is installed securely.
- Push the clips into place securely.