Rearview Mirror Replacement

Rearview Mirror Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*

VAN, LX and EX Models ('07 Model)

1. Release the hooks (A), then pull the mirror base cover (B) down.






2. Pull down the hook (A) to release it from the mount (B), and the slide the mirror base (C) rearward, then remove the rearview mirror (D).






3. Fit the mirror base (A) over the mount (B), and secure the rearview mirror by the spring (C) and the hook (D).






VAN, DX, LX, and EX Models ('08-10 Models)

1. Turn the rearview mirror base (A) 90°.






2. Slide the rearview mirror base (A) down toward the bottom of the windshield to detach it from the spring (B) in the mount (C).






3. If necessary, remove the spring from the mount.

4. Install the rearview mirror in the reverse order of removal.

EXL (with Navigation), Touring Models

1. Slide the mirror harness upper cover (A) forward, then remove the mirror harness cover (B).






2. Remove the mirror harness holder (A), then disconnect the rearview mirror connector (B).






3. Turn the rearview mirror base (A) 90 °.






4. Slide the rearview mirror base (A) down toward the bottom of the windshield to detach it from the spring (B) in the mount (C).





5. If necessary, remove the spring from the mount.

6. Install the rearview mirror in the reverse order of removal.

EXL (without Navigation) model

NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the roof console Service and Repair.

2. Disconnect the rearview mirror connector (A), and slide the mirror harness cover (B) forward, then remove the screw with a TORX T20 bit from the mirror base (C).






3. While holding the rearview mirror (A), the mirror harness connector (B) out through the headliner (C), then remove the rearview mirror from the mount (D).





4. Install the mirror in the reverse order of removal, and note these items:

- Before installing the rearview mirror, remove the TORX screw, and apply medium strength liquid thread lock to it.
- Make sure the rearview mirror connector is plugged in properly.