Driver's Power Seat Motor Test

Driver's Power Seat Motor Test

1. Remove the driver's seat Front Seat Removal/Installation.

2. Disconnect the connector from each power seat motor.

NOTE: All connectors are terminal side of male terminals.






3. Test each motor by connecting power and ground according to the table. When the motor stops running, disconnect battery power immediately.





4. If the motor does not run or fails to run smoothly, replace:

- Slide motor Front Seat Linkage Disassembly/Reassembly - Divers 8-Way Power
- Front up-down motor Front Seat Linkage Disassembly/Reassembly - Divers 8-Way Power
- Rear up-down motor Front Seat Linkage Disassembly/Reassembly - Divers 8-Way Power

NOTE: For recline motor, check for an open in the recline motor subharness. If the harness is OK, replace the recline motor Front Seat Linkage Disassembly/Reassembly - Divers 8-Way Power.