Dashboard Center Lower Cover Removal/Installation

Dashboard Center Lower Cover Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Take care not to scratch the dashboard or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. From under the dash, remove the driver's heater lower cover (A) and the passenger's heater lower cover (B).

1. Detach the clips (C, D).

2. Release the hook (E) and the stud (F).





2. Open the beverage holder (A), and remove the screws.






3. Remove the dashboard center lower cover (A).

1. Pull out the cover to detach the clips (B, C).

2. Disconnect the driver's/passenger's accessory power socket connectors (D).

3. For some models: Disconnect the seat heater connectors (E).





4. Install the cover in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure that each connector is plugged in properly.
- Push the clips and the hook into place securely.