ODS Unit Replacement

ODS Unit Replacement

'08-10 models

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the front passenger's seat assembly Front Seat Removal/Installation and seat-back cover Front Seat-back Cover Replacement.

3. Remove the cover (A), then disconnect the ODS unit harness 18P connector (B) and OPDS sensor connectors (C) from the ODS unit (D).





4. Remove the two mounting nuts (E) and the ODS unit.

Installation

1. Place the ODS unit (A) on the seat-back frame. Install the two mounting nuts (B), and connect the ODS unit harness 18P connector (C) and OPDS sensor connectors (D) to the ODS unit. Reinstall the cover (E).





2. Install the seat-back cover in the reverse order of removal Front Seat-back Cover Replacement.

3. Install the front passenger's seat assembly Front Seat Removal/Installation.

4. Do the battery terminal reconnection procedure Procedures.

5. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.

6. Clear any DTCs Reading and Clearing Diagnostic Trouble Codes.

7. Do the ODS unit initialization Programming and Relearning.

8. Confirm proper operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about
6 seconds and then go off.