Steering Gear: Adjustments

Steering Rack Guide Adjustment

Special Tools Required

- Locknut Wrench, 43 mm 07MAA-SL00200 or 07MAA-SL0020A

1. Set the front wheels in the straight ahead position.

2. Loosen the rack guide screw locknut (A) with the locknut wrench, then remove the rack guide screw (B).






3. Remove the old sealant from the rack guide screw (A), and apply new sealant (Loctite 565) to the middle of the threads (B). Loosely install the rack guide screw on the steering gearbox.

NOTE: If more than 5 minutes have passed after applying the sealant, remove the old sealant and residue, and reapply new sealant.





4. Tighten the rack guide screw to 25 Nm (2.5 kg-m, 18 lb-ft), then loosen it.

5. Retighten the rack guide screw to 3.9 Nm (0.4 kg-m, 2.9 lb-ft), then back it off to the specified angle.





6. Hold the rack guide screw stationary with a wrench, and install the locknut by hand until it's fully seated.

7. Install the locknut wrench on the locknut, and hold the rack guide screw stationary with a wrench. Tighten the locknut to the specified torque.

8. Check for unusual steering effort throughout the complete turning range.

9. Check the steering wheel rotational play Steering Wheel Rotational Play Check, and the power assist Power Steering Assist Check.