Scuff Plate: Service and Repair

Interior Trim Removal/Installation - Door Areas

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

Front Door Sill Area

NOTE:

- Put on gloves to protect your hands.
- Take care not to bend or scratch the trim and panels.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Detach the hooks (A) and the tabs (B) from the kick panel (C) and the B-pillar lower trim (D), and pull the front door sill trim (E) up by hand to detach the clips (F), then remove it from the front door opening seal (G).





2. If necessary, pull the front side outer trim (H) up to detach the clips (I), then remove the trim.

3. Remove the driver's side kick panel (A) or the passenger's side kick panel (B).

1. Pull out the door opening seal (C) as needed from the kick panel hooks (D) and the door opening flange.

2. Pull the kick panel back by hand to detach the clips, then remove it.

Driver's side





Passenger's side





4. Pull out the front door opening seal (A) from the trim hooks (B) and around the front door opening flange, then remove the seal.






5. Install the trim in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips and hooks into place securely.

Rear Door Sill Area

NOTE:

- Put on gloves to protect your hands.
- Take care not to bend or scratch the trim and panels.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the second row seat Second Row Seat Removal/Installation.

2. Detach the hook (A) and the tab (B) from the B-pillar lower trim (C), and pull the rear door sill trim (D) up by hand to detach the clips (E, F, G), then remove it from the rear door opening seal (H).





3. If necessary, pull the rear side outer trim (I) up to detach the clips (J), then remove the trim.

4. Pull out the rear door opening seal (A) from the trim hooks (B) and around the rear door opening flange, then remove the seal.





5. Install the trim in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips and hooks into place securely.