Driver's Airbag Replacement

Driver's Airbag Replacement

NOTE: If replacing the driver's airbag after deployment, Component Replacement/Inspection After Deployment Service and Repair for a complete list of other parts that must also be replaced.

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) from the cable reel 4P connector.






3. Remove the two TORX bolts (A), using a TORX T30 bit.





4. Remove the driver's airbag (B).

Installation

NOTE: If you are replacing a deployed airbag, inspect the cable reel for heat damage. If there is any damage, replace the cable reel.

1. Place the driver's airbag (A) in the steering wheel, and secure it with new TORX bolts (B), using a TORX T30 bit.






2. Connect the driver's airbag 4P connector (A) to the cable reel 4P connector, then install the access panel (B) on the steering wheel.





3. Do the battery terminal reconnection procedure Procedures.

4. Clear any DTCs with the HDS.

5. After installing the airbag, confirm proper system operation:

- Turn the ignition switch to ON (II); and check that the SRS indicator comes on for about 6 seconds and then goes off.
- Make sure the horn and turn signal switches work properly.
- Make sure the steering wheel switches work properly.