Moonroof Drain Channel Replacement

Moonroof Drain Channel Replacement

1. Fully close the moonroof, then place it in the full tilt-up position.

2. Remove the glass Service and Repair.

3. Disconnect the rod clips (A), then remove the drain channel rods (B) on both sides.

NOTE: If the bushings are damaged or stress-whitened, replace them with new ones.






4. Slide the drain channel (A) forward.






5. Pull up the rear edge of the drain channel (A) while pushing both clips (B), and release the channel from both hooks (C) of the drain channel slider by pulling it rearward.





6. Remove the drain channel.

7. Install the drain channel in the reverse order of removal, and note these items:

- Push the clip portions into place securely.
- Check the glass position adjustment Adjustments.

8. Check for water leaks. Let the water runs freely from a hose without a nozzle. Do not use a high-pressure spray.