Driver's Dashboard Lower Cover Removal/Installation

Driver's Dashboard Lower Cover Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the dashboard or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Open the front door, and remove the driver's dashboard side cover (A).

1. Pull out the front door opening trim (B), as needed.

2. Pry up on the lower edge of the dashboard side cover at the notch (C) to detach the clip (D).

3. Gently pull out along the edge to release the clips (E).





2. Remove the driver's dashboard lower cover (A).

1. Remove the screw from the driver's dashboard lower cover.

2. Pull out the bottom of the driver's dashboard lower cover to detach the clips and the hooks (B).

3. Disconnect the VSA OFF switch connector (C), the front fog light switch connector (D) if equipped, the in-car temperature sensor connector (E), and the air hose (F).





3. Install the cover in the reverse order of removal, and note these items:

- Make sure each connector is plugged in properly, and the air hose is connected properly.
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips and the hooks into place securely.