Air Bag Systems: Service and Repair

SRS Component Replacement/Inspection After Deployment

NOTE:

- Before doing any SRS repairs, clear the DTCs with the HDS for the less obvious deployed parts (seat belt tensioners, front impact sensors, side impact sensors, etc.)
- Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting. Because it could complicate troubleshooting other DTCs.
- After a vehicle collision, do the ODS unit operation check ODS Unit Operation Check.
- After a vehicle collision, inspect the front seat active head restrains Testing and Inspection.

After a collision where the seat belt tensioners deployed, replace these items:

- SRS unit
- Seat belt tensioners
- Front impact sensors

After a collision where the front airbag(s) deployed, replace these items:

- SRS unit
- Deployed airbag(s)
- Seat belt tensioners
- Front impact sensors
- Dashboard

After a collision where the side airbag(s) deployed, replace these items:

- SRS unit
- Deployed side airbag(s)
- Side impact sensor(s) (first) for the side(s) that deployed
- Side impact sensor(s) (second) for the side(s) that deployed
- B-pillar lower trim
- Seat frame and related parts
- Seat belt tensioners

After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:

- SRS unit
- Deployed side curtain airbag(s)
- Seat belt tensioner(s) for the side(s) that deployed
- Side impact sensor(s) (first) for the side(s) that deployed
- Side impact sensor(s) (second) for the side(s) that deployed
- Roof trim
- A-pillar trim
- B-pillar lower trim
- C-pillar trim
- Front grab handle
- Rear grab handle
- All related trim clips
- Sunvisor
- Coat hooks

After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed.

A-Pillar Trim





B-Pillar Trim





C-Pillar Trim





During the repair process, inspect these areas:

- Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses.
- Inspect the cable reel for heat damage. If there is any damage, replace the cable reel.

After the vehicle is completely repaired, turn the ignition switch to ON (II). If the SRS indicator comes on for about 6 seconds and then goes off, the SRS is OK. If the indicator does not function properly, use the HDS to check for the DTCs with HDS. If you cannot retrieve a code, do the SRS Symptom Troubleshooting.

Checking and Adjusting the Headliner/Pillar Trim Overlap

To prevent the side curtain airbag from deploying and damaging the pillar trim, the overlap between the headliner and all pillar trim must be less then 15 mm (0.6 in). To check the overlap, do this:

1. Install the headliner (A) and the pillar trim (B).






2. Apply masking tape on the headliner to mark the upper edge of each pillar trim.






3. Remove the pillar trim, and measure the headliner overlap.

- If the overlap is less than 15 mm (0.6 in), remove the tape, and install the pillar trim.
- If the overlap is more than 15 mm (0.6 in), go to step 4.





4. Carefully trim the headliner with a utility knife, reducing the overlap to less than 15 mm (0.6 in).





5. Remove the tape, and install the pillar trim.