P0970

DTC P0970: CVT Start Clutch Pressure Control Valve Circuit Low Voltage
2005 Model

NOTE:
^ Record all freeze data and review General Troubleshooting Information before you troubleshoot.
^ This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.

1. Clear the DTC with the HDS.
2. Check that DTC P0970 recurs.
Is DTC P0970 indicated?
YES- Go to step 6.
NO- Go to step 3.
3. Set the parking brake, and block the front wheels securely.
4. Start the engine, fully press the brake pedal, and shift to the D position.
5. Check that DTC P0970 recurs.
Is DTC P0970 indicated?
YES- Go to step 6.
NO- Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the solenoid harness connector, TCM and the CVT start clutch pressure control valve.
6. Turn the ignition switch OFF.
7. Disconnect the solenoid harness connector (8P).





8. Measure the resistance between solenoid harness connector (8P) terminals No.4 and No.8.
Is there 3.8 - 6.3 ohms?
YES- Go to step 9.
NO- Remove the lower valve body, and check for an open or a short in the solenoid harness. If the wire is OK, replace the CVT start clutch pressure control valve, then go to step 14.
9. Disconnect TCM connector A (26P).





10. Check for continuity between TCM connector terminals A1 and body ground, and between A14 and body ground.
Is there continuity?
YES- Repair short to ground in the wire between TCM connector terminal A1 and the solenoid harness connector, or between A14 and the connector.
NO- Go to step 11.
11. Connect the solenoid harness connector (8P).





12. Measure the resistance between TCM connector terminals A1 and A14.
Is there 3.8 - 6.8 ohms?
YES- Go to step 13.
NO- Repair open in the wire between TCM connector terminal A1 and the solenoid harness connector, or between A14 and the connector





13. Check for continuity between TCM connector terminals A4 and body ground, A13 and body ground, A17 and body ground, and between A26 and body ground.
Is there continuity?
YES- Substitute a known-good TCM, then recheck. If the symptom/indication goes away with a known-good TCM, replace the original TCM.
NO- Repair open in the wires between TCM connector terminals A4, A13, A17, A26, and ground (G101), or repair poor ground (G101).
14. Clear the DTC with the HDS.
15. Check that DTC P0970 recurs.
Is DTC P0970 indicated?
YES- Return to step 6 and recheck.
NO- The problem has been corrected.