VSA Activation Indicator Does Not GO Off, and No DTCs Are Stored
VSA activation indicator does not go off, and no DTCs are storedNOTE: Do the VSA natural position memorization first, if the indicator remains on, proceed with the flow chart.
1. Turn the ignition switch ON (II), and watch the VSA activation indicator.
Does the VSA activation indicator go off?
YES-The system is OK at this time.
NO-Go to step 2.
2. Turn the ignition switch OFF,
3. Check the VSA OFF switch.
Is the switch OK?
YES - Go to step 4.
NO - Replace the VSA OFF switch.
4. Remove the gauge assembly.
5. Disconnect the gauge assembly connector B (30P).
6. Disconnect the VSA modulator-control unit 47P connector.
7. Check for continuity between the VSA modulator control unit 47P connector terminal No. 35 and body ground.
Is there continuity?
YES - Repair short to body ground in the wire re between the gauge assembly and the VSA modulator-control unit.
NO - Go to step 8.
8. Disconnect the VSA OFF switch 6P connector.
9. Check for continuity between the VSA modulator control unit 47P connector terminal No. 27 and body ground.
Is there continuity?
YES - Repair short to body ground in the wire between the VSA OFF switch and the VSA modulator-control unit.
NO - Go to step 10.
10. Substitute a known-good VSA modulator-control unit.
11. Reconnect all of the disconnected connectors.
12. Turn the ignition switch ON (II).
13. Clear the DTC using the HDS.
14. Test-drive the vehicle.
Does the VSA activation indicator go off?
YES - Replace the original VSA modulator-control unit.
NO - Check for loose terminals in the gauge assembly connectors. If necessary, substitute a known-good gauge assembly, and retest.