Secondary Shaft 2nd Gear Axial Clearance Inspection

Secondary Shaft 2nd Gear Axial Clearance Inspection

1. Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 37 x 58 mm thrust washer (E), and the 2nd clutch (F) on the secondary shaft (G), then secure them with the set ring (H). Do not install the O-rings during inspection.






2. Measure the clearance between the set ring (A) and the 2nd clutch guide (B) using a feeler gauge (C), in at least three places. Use the average as the actual clearance.





3. If the clearance is out of standard, remove the 37 x 58 mm thrust washer, and measure its thickness.

4. Select and install a new thrust washer, then recheck.

THRUST WASHER, 37 x 58 mm





5. After replacing the thrust washer, make sure the clearance is within standard.

6. Disassemble the installed parts from the secondary shaft.