Side Curtain Airbag Replacement

Side Curtain Airbag Replacement

NOTE: If replacing the side curtain airbag after deployment, refer to Component Replacement/Inspection After Deployment Service and Repair for a complete list of other parts that must also be replaced.

Removal

NOTE:

- Review the interior trim replacement procedure before doing repair or service. Locations

- Removal of the side curtain airbag must be done according to Precaution and Procedures. Technician Safety Information

- The side curtain airbag system consists of many components. When the side curtain airbag has been deployed, go to Component Replacement/Inspection After Deployment, and replace all of the parts listed. Service and Repair

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the cargo area side trim. Interior Trim Removal/Installation - Rear Side Area

3. Disconnect the floor wire harness 2P connector (A) from the side curtain airbag.

4. Remove the headliner. Service and Repair






5. Remove the side airbag mounting bolts (A) and mounting screws (B) from the bracket. Detach the clip (C), then remove the side curtain airbag (D).






Installation

NOTE:

- Installation of the side curtain airbag must be done according to the Precautions and Procedures. Technician Safety Information

- If the airbag is frayed, or has any other visible damage, replace it. Do not attempt to repair an airbag.

- When you install the airbag, make sure it is not twisted, and that it is not caught between the inflator bracket by the bracket bolts.

- Make sure that the side curtain airbag inflator retainer is installed properly. Otherwise the airbag could incorrectly deploy and cause damage or injuries.

- Make sure the side curtain airbag and the securing tape is not cut or is peeling. If the airbag or the tape is cut or is peeling, replace the airbag.

1. Place the side curtain airbag assembly on the side of the roof, and fit its clip (A) into the holes in the body. Tighten the new side curtain airbag mounting bolts (B) and mounting screws (C).






2. Connect the floor wire harness 2P connector (A) to the side curtain airbag.

3. Do the battery terminal reconnection procedure. Procedures

4. Connect the HDS, and clear the DTCs. Initial Inspection and Diagnostic Overview

5. After installing the side curtain airbag, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.

6. Install all removed parts.

7. Confirm proper headliner/pillar trim overlap. Service and Repair