Convertible Top A-Pillar-Header Weatherstrip and A-Pillar Molding Replacement

Convertible Top A-Pillar-Header Weatherstrip and A-Pillar Molding Replacement

NOTE:

- Take care not to scratch the body.

- Use a clip remover to remove the clips.

1. Remove the A-pillar-header weatherstrip and the A-pillar-molding as shown.

2. Install the weatherstrip and molding in the reverse order of removal, and note these items:
- If the old molding will be reinstalled, scrape off the double-sided adhesive tape, then clean the molding surface with isopropyl alcohol. Attach new double-sided adhesive tape to the molding.

- When installing the molding, first tighten the screw at the top of the molding.

- If the clips are damaged or stress-whitened, replace them with new ones.

- If the old weatherstrip will be reinstalled, scrape off all traces of old EPT sealer and butyl tape, then clean the weatherstrip surface with isopropyl alcohol. Attach new EPT sealer and butyl tape to the weatherstrip.

- When installing the weatherstrip, align the roof clip hole on the weatherstrip with the hole on the molding.

- Before installing the weatherstrip, fold the separator of the butyl tape at the roof portion. After installing the weatherstrip, carefully pull the separator away.

- Press the butyl tape portions to make the adhesive stick.

- Check that each door glass contacts the weatherstrip evenly.

- Check for water leaks. Adjustments