Navigation Communication Line Circuit Troubleshooting

Navigation Communication Line Circuit Troubleshooting

1. Operate the climate control system in several modes.

Is the climate control system OK?

YES -

Go to step 2.

NO -

Do the Self-Diagnostic Function with the HDS or the climate control unit.�

2. Do the System Links in navigation System Diagnostic Mode.

Is the A/C icon red?

YES -

Go to step 3.

NO -

Disconnect navigation unit connector B (32P), then go to step 9.

3. Turn the ignition switch to LOCK (0).

4. Disconnect navigation unit connector B (32P).

5. Disconnect climate control unit connector B (12P).

6. Check for continuity between the following terminals of climate control unit connector B (12P) and navigation unit connector B (32P).









Is there continuity?

YES -

Go to step 7.

NO -

Repair an open in the wire(s) between the climate control unit and the navigation unit.�

7. Check for continuity between body ground and climate control unit connector B (12P) terminals No. 7, No. 8, and No. 9 individually.





Is there continuity?

YES -

Repair a short to body ground in the wire(s) between the climate control unit and the navigation unit.�

NO -

Go to step 8.

8. Reconnect climate control unit connector B (12P).

9. Connect navigation unit connector B (32P) terminals No. 4, No. 20, and No. 21 with jumper wires.






10. Press and hold both the AUTO button, then press and hold the OFF button ('08-09 models) or ON/OFF button ('10-11 models), then turn the ignition switch to ON (II).

11. Check the mode indicator displaying in the audio-HVAC subdisplay unit.





Is the HEAT/VENT indicator solid with the remaining icons blinking?

YES -

Do the Unit check with the navigation system.�

NO -

Substitute a known-good climate control unit, and recheck. If the symptom goes away, replace the original climate control unit Climate Control Unit Removal/Installation (With Navigation).�