Speaker Test/Replacement

Speaker Test/Replacement

Front Door Speaker

1. Remove the door panel:

- 4-door Front Door Panel Removal/Installation (4-Door)
- 2-door Front Door Panel Removal/Installation (2-Door)

2. Remove the bolt (A). Then lift the speaker (B) straight up to release the lower clips (C).

NOTICE
If you pull the speaker out too far from the door, you will damage the lower clips.





3. Disconnect the 2P connector (D), and remove the speaker.

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 4 Ohms.

5. If the resistance is not as specified, replace the door speaker.

Front Door Tweeter (with premium audio)

1. Detach the clip (A), and remove the front door tweeter cover (B). Then disconnect the connector (C).






2. Measure the resistance between the front door tweeter 2P connector terminals No. 1 and No. 2. There should be about 3.3 Ohms.






3. If the resistance is not as specified, replace the front door tweeter. Remove the front door tweeter (A) from front door tweeter cover (B).






Front Door Tweeter (without premium audio)

1. Detach the clip (A), and remove the front door tweeter cover (B). Then disconnect the connector (C).






2. Remove the front door tweeter (A) from the front tweeter cover (B).






3. Check the capacitor condition. If any malfunction is found, replace the front door tweeter.

4. Measure the resistance between the front door tweeter (A) terminal No. 2 and the outside terminal of the capacitor. There should be about 4 Ohms.





5. If the resistance is not as specified, replace the front door tweeter.

Rear Speaker

1. Remove the rear shelf Service and Repair.

2. Remove the bolt (A), then tilt the speaker (B) forward to release the front clips (C).

NOTICE
If you pull the speaker out too far from the rear bulkhead, you will damage the lower clips.





3. Disconnect the 2P connector (D), and remove the rear speaker.

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 4 Ohms.

5. If the resistance is not as specified, replace the rear speaker.

Subwoofer

1. Remove the rear shelf Service and Repair.

2. Remove the four bolts (A) from the subwoofer (B).





3. Disconnect the 2P connector (C), and remove the subwoofer.

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 2 Ohms.

5. If the resistance is not as specified, replace the subwoofer.