Tweeter Test

Tweeter Test

Removal

NOTE: SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. Front Door Opening Seal as Needed





1. Remove the front door opening seal (A) as needed.

2. A-Pillar Trim





1. Pull out the A-pillar trim (A) to release the clips.





2. Put a shop towel (A) in the opening between the A-pillar trim (B) and the dashboard to prevent dropping the A-pillar clips.





3. Remove the A-pillar trim (A).

NOTE: The upper clip (B) will stay in the body.





4. Remove the upper clip (A) from the body.

Test

1. Tweeter - Test





1. Measure the resistance between terminal No. 2 and the outside terminal of the capacitor (A). There should be about 4 Ohms. Also check the capacitor condition.

2. If any problem is found, replace the tweeter (B).

Installation

NOTE: SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. A-Pillar Trim





1. Carefully install the new upper clip (A) to the A-pillar trim (B).





2. Install the A-pillar trim (A).

NOTE:
* Make sure the side curtain airbag is not tucked under the clips or the trim ribs.
* Do not push too hard on the A-pillar trim. If you push too hard, the clip will be damaged, and it will not hold the trim properly.
* Gently tug on the A-pillar trim to verify that all clips are securely fastened.

2. Front Door Opening Seal as Needed





1. Install the front door opening seal (A).