Air Bag Deactivation Indicator: Service and Repair

Front Passenger's Airbag Cutoff Indicator Removal and Installation

Removal

NOTE: SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. Battery Terminal (SRS) - Disconnection





1. Make sure the ignition switch is in LOCK (0).

2. Disconnect and isolate the negative cable and battery sensor (A) from the battery (B).

NOTE: Always disconnect the negative side first.

3. Disconnect the positive cable (C) from the battery.

4. Wait at least 3 minutes before starting work.

2. Driver's Dashboard Lower Cover





1. Remove the driver's dashboard lower cover (A).

3. Dashboard Subdisplay Visor





1. Remove the dashboard subdisplay visor (A).

4. Dashboard Meter Visor





1. Remove the dashboard meter visor (A).

5. Information Display Unit





1. Remove the information display unit (A).

2. Disconnect the connectors from the information display unit.

6. Multi-Information Display Unit





1. Remove the multi-information display unit (A).

2. Disconnect the connectors.

7. Front Passenger's Airbag Cutoff Indicator





1. Remove the front passenger's airbag cutoff indicator (A).

Installation

NOTE: SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. Front Passenger's Airbag Cutoff Indicator





1. Install the front passenger's airbag cutoff indicator (A).

2. Multi-Information Display Unit





1. Connect the connectors.

2. Install the multi-information display unit (A).

3. Information Display Unit





1. Connect the connectors to the information display unit (A).

2. Install the information display unit.

4. Dashboard Meter Visor





1. Install the dashboard meter visor (A).

5. Dashboard Subdisplay Visor





1. Install the dashboard subdisplay visor (A).

6. Driver's Dashboard Lower Cover





1. Install the driver's dashboard lower cover (A).

7. Battery Terminal (SRS) - Reconnection





NOTE: If the battery performs abnormally, test the battery.

1. Clean the battery terminals.

2. Connect the positive cable (A) to the battery (B).

NOTE: Always connect the positive side first.

3. Connect the negative cable and battery sensor (C) to the battery.

4. Apply multipurpose grease to the terminals to prevent corrosion.

8. HDS DLC - Connection





1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.

2. Turn the ignition switch to ON (II).

3. Make sure the HDS communicates with the vehicle. If it does not communicate, go to the DLC circuit troubleshooting.

9. DTC - Clear

1. Clear the DTC(s) by following the screen prompts on the HDS.

2. Turn the ignition switch to LOCK (0), then wait for 10 seconds.

10. Confirm Proper SRS Operation

Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.