Dashboard Center Display Visor Removal / Installation (With Navigation)

Dashboard Center Display Visor Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*

With Navigation

NOTE:

- Take care not to scratch the dashboard or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the center dashboard vent.

2. Remove the center display visor (A).

1. Remove the screws (B).

2. Pull out the upper edge of the visor to detach the upper clips (C).

3. Pull out the visor to detach the side clips (D).

NOTE: If the non-woven fabric (E) on the upper clips are damaged, replace them with new ones.





3. Install the visor in the reverse order of removal, and note these items:

- If the clips are damaged, replace them with new ones.
- If the upper clip is replaced, attach the new non-woven fabric (A) around the new clip (B) as the following procedures:
- After installing the new clip to the visor (C), clean the clip and the visor surfaces with a shop towel dampened with isopropyl alcohol. After cleaning, keep oil, grease, and water from getting on the surface.
- Attach the non-woven fabric with adhesive tape around the clip.

- Push the clips into place securely.