Rear Seat Cushion Cover/Pad Replacement

Rear Seat Cushion Cover/Pad Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*

NOTE:

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to tear or damage the seat covers.
- Put on gloves to protect your hands.
- The left rear seat cushion is shown, the right rear seat cushion is similar.

1. Remove the rear seat assembly Rear Seat Removal/Installation.

2. Remove the rear seat cushion Rear Seat Disassembly/Reassembly.

3. Remove the screw and the clip, then release the hook (A) and remove the recline cover (B).






4. Lift the leg (A), and remove the rear seat undercover cap (B).

Left rear seat cushion





Right rear seat cushion





5. Remove the screws (A, B) and the knobs (C). Release the hook strip (D) of the seat cushion cover (E) from the edge of the rear seat undercover (F) all the way around.

Left rear seat cushion





Right rear seat cushion





6. Remove the rear seat undercover (A) from the seat cushion frame (B).

1. Left seat cushion: Pry out the lid (C) with the appropriate trim tool.

2. Lift the front edge of the undercover up to release the hooks (D) from the frame wire.

Left rear seat cushion





Right rear seat cushion





7. Release the hooks (A) from the seat-back frame (B).

Left rear seat cushion





Right rear seat cushion





8. Remove the rear seat cushion cover/pad (A) and the silencer (B) from the rear seat cushion frame (C).





9. Install the rear seat cushion cover/pad in the reverse order of removal. To prevent wrinkles when installing the seat-back cover, make sure the material is stretched evenly over the pad before securing the hooks.