Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Pulley Removal and Installation

Special Tools Required

- Crankshaft Pulley Holder 07AAB-RJAA100
- Socket, 19 mm 07JAA-001020A
- Holder Handle 07JAB-001020B

Removal

1. Raise the vehicle on the lift.

2. Remove the right front wheel.

3. Remove the splash shield Splash Shield Replacement.

4. Remove the drive belt Service and Repair.

5. Hold the pulley with the holder handle (A) and the crankshaft pulley holder (B).





6. Remove the bolt with a socket, 19 mm (C) and a breaker bar, then remove the crankshaft pulley.

Installation

1. Remove any oil and clean the crankshaft pulley (A), the crankshaft (B), the bolt (C), and the washer (D). Lubricate with new engine oil as shown.





2. Install the crankshaft pulley.

3. When a new crankshaft or a new pulley bolt is installed: Tighten the crankshaft pulley bolt. Do not use an impact wrench.

- Hold the pulley with the holder handle (A) and crankshaft pulley holder (B), tighten the bolt to 177 N-m (18.0 kgf-m, 130 lbf-ft) with a torque wrench and a socket (C), then remove the bolt.
- Tighten the bolt to 39 N-m (4.0 kgf-m, 29 lbf-ft) with a torque wrench and a socket.
- Tighten the bolt an additional 94 °.










4. When the crankshaft or the pulley bolt is reused: Tighten the crankshaft pulley bolt. Do not use an impact wrench.

1. Hold the pulley with the holder handle (A) and crankshaft pulley holder (B), then tighten the bolt to 37 Nm (3.8 kg-m, 27 lb-ft) with a torque wrench and a socket (C).

2. Tighten the bolt an additional 90 °.










5. Install the drive belt Service and Repair.

6. Install the splash shield Splash Shield Replacement.

7. Install the right front wheel.