Side Airbag Replacement

Side Airbag Replacement

NOTE: If replacing the side airbag after deployment, refer to Component Replacement/Inspection After Deployment Service and Repair for a complete list of other parts that must also be replaced.

Removal

1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. Remove the front seat assembly Front Seat Removal/Installation.

3. Pull off the seat-back cover/pad as needed Service and Repair.

4. Release the rear hooks (A) from the seat-back frame (B).





5. Remove the mounting nut (C) and the side airbag (D).

Installation

NOTE:

- If the side airbag lid is secured with tape, remove the tape.
- Do not open the lid on the side airbag cover.
- Use new mounting nut tightened to the specified torque.
- Make sure that the seat-back cover/pad is installed properly. Improper installation may prevent proper deployment.
- Be sure to install the harness so that it is not pinched or interfering with other parts.

1. Place the side airbag (A) on the seat-back frame. Install the new side airbag mounting nut (B).





2. Install the rear hooks (C) in the seat-back frame (D).

3. Install the seat-back cover/pad Service and Repair.

4. Install the front seat assembly Front Seat Removal/Installation. then connect the floor wire harness 2P connector.

5. Move the front seat and the seat-back through their full ranges of movement, making sure the harness are not pinched or interfering with other parts.

6. Do the battery terminal reconnection procedure.

7. Clear any DTCs with the HDS.

8. After installing the side airbag, confirm proper system operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.