Trunk / Liftgate Shock / Support: Service and Repair

Strut Replacement - Liftgate

Removal Procedure





Caution: Refer toHood Hold-Open Device Caution in Cautions and Notices.

Notice: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.

1. Open the liftgate.
2. Support the liftgate.
3. Carefully pry the retaining clip in order to remove the lower end of the liftgate strut (1) from the ball stud on the body.
4. Carefully pry the retaining clip in order to remove the upper end of the liftgate strut (2) from the ball stud on the liftgate.
5. Remove the liftgate strut from the vehicle.



Installation Procedure





1. Install the liftgate strut to the vehicle ball studs.
2. Push on the end of the strut in order to install the upper end of the liftgate strut (2) to the ball stud of the liftgate.
3. Push on the end of the strut in order to install the lower the end of the liftgate strut (1) to the ball stud on the body.
4. Close the liftgate.