Front Safety Belt Buckle

Front Safety Belt Buckle

Removal

WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Service and Repair
2 Make the SRS system safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
3 Remove the front seat. For additional information, refer to Front Seat Front Seat




4 Remove the seat backrest hinge cover.
- Remove the 2 screws.




5 Remove the front safety belt buckle.
- Remove the Torx bolt.
- Disconnect the 2 electrical connectors.
- Release the wiring harness.

Installation
1 Install the front safety belt buckle.
- Tighten the Torx bolt to 40 Nm (30 lb.ft).
- Connect the electrical connectors.
- Attach the wiring harness.
2 Install the seat backrest hinge cover.
- Tighten the screws.
3 Install the front seat. For additional information, refer to Front Seat Front Seat
4 Connect the battery ground cable.