Upper Glove Compartment

Upper Glove Compartment

Removal

WARNING: Persons working on the supplemental restraint system (SRS) must be fully trained and have been issued with the safety guidelines.

WARNING: Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.

WARNING: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.

WARNING: The correct procedures must always be used when working on SRS components.

WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

WARNING: Take extra care when handling SRS components.
1 Make the air bag supplemental restraint system (SRS) safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
2 Disconnect the battery ground cable. For additional information, refer to Procedures
3 Remove the lower glove compartment. For additional information, refer to Lower Glove Compartment Lower Glove Compartment




4 Remove the 2 screws from the compact disc (CD) changer bracket.
5 Open the upper glove compartment.




6 Remove the upper glove compartment finisher trim panel.
- Remove the screw.
- Release the 3 clips.




7 Remove the 3 screws from the upper glove compartment.




8
CAUTION: Care must be taken to avoid damaging the upper glove compartment release mechanism.
Remove the upper glove compartment.
- Disconnect the upper glove compartment latch electrical connector.
- If installed, disconnect the electrical connector from the portable camera docking station.
- Disconnect the coaxial cable from the portable camera docking station.
- Disconnect the CD changer electrical connector.




9
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the CD changer.
- Remove the 3 screws securing the CD changer bracket to the upper glove compartment.





10 Remove the upper glove compartment latch.
- Remove the 3 screws.





11 Release and remove the portable camera from the portable camera docking station.





12 Remove the portable camera docking station.
- Remove the 2 screws.





13 Remove the upper glove compartment lid.
- Remove the 6 screws from the upper glove compartment lid.
- Collect the upper glove compartment striker.

Installation
1 Install the upper glove compartment lid.
- Position the upper glove compartment striker.
- Install the 6 screws to the upper glove compartment lid.
2 Install the portable camera docking station.
- Install the 2 screws.
3 Install the portable camera to the portable camera docking station.
4 Install the upper glove compartment latch.
- Install the 3 screws.
5 Install the CD changer.
- Install the 3 screws securing the CD changer bracket to the upper glove compartment.
6
CAUTION: Care must be taken to avoid damaging the upper glove compartment release mechanism.
Install the upper glove compartment.
- Connect the CD changer electrical connector.
- Connect the portable camera docking station coaxial cable.
- Connect the portable camera docking station electrical connector.
- Connect the upper glove compartment latch electrical connector.
7 Install the 3 screws to the upper glove compartment.
8 Install the upper glove compartment finisher trim panel.
- Secure the 3 clips.
- Install the screw.
9 Close the upper glove compartment.

10 Install the 2 screws to the CD changer bracket.

11 Install the lower glove compartment. For additional information, refer to Lower Glove Compartment Lower Glove Compartment

12 Connect the battery ground cable. For additional information, refer to Procedures