Removal

SUSPENSION: REAR NO. 2 SUSPENSION ARM:

REMOVAL
NOTE:
Check if an old gasket still remains on the pipe. If so, remove it. Also, check if any bolts or nuts are rusted. If so, replace them.

1. REMOVE REAR WHEEL
2. REMOVE TAIL EXHAUST PIPE ASSEMBLY Removal
3. REMOVE CENTER EXHAUST PIPE ASSEMBLY Removal
4. SEPARATE REAR STABILIZER LINK ASSEMBLY LH Removal
5. SEPARATE REAR STABILIZER LINK ASSEMBLY RH
6. REMOVE REAR STABILIZER BAR NO. 1 BRACKET Removal
7. REMOVE REAR STABILIZER BAR
8. REMOVE REAR STABILIZER BUSHING Removal
9. SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ HID Headlight System)





(a) Remove the nut and separate the rear height control sensor sub-assembly RH from the rear No. 2 suspension arm RH.
10. SEPARATE REAR STRUT ROD Removal
11. SEPARATE REAR NO. 2 SUSPENSION ARM LH Removal
12. SEPARATE REAR NO. 2 SUSPENSION ARM RH Removal
13. SEPARATE REAR NO. 1 SUSPENSION ARM LH Removal
14. SEPARATE REAR NO. 1 SUSPENSION ARM RH Removal
15. REMOVE REAR SUSPENSION MEMBER LOWER STOPPER LH Removal
16. REMOVE REAR SUSPENSION MEMBER LOWER STOPPER RH Removal
17. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY Removal
18. REMOVE REAR NO. 2 SUSPENSION ARM LH





(a) Remove the bolt, and the rear No. 2 suspension arm LH.