Front Drain Hose Removal/Installation

FRONT DRAIN HOSE REMOVAL

1. Remove the following parts:
1. Console (4 door)
2. A-pillar trim
3. Upper anchor of the front seat belt
4. Front scuff plate
5. Rear scuff plate
6. B-pillar lower trim
7. B-pillar upper trim
8. Rear seat
9. Tire house trim
10. Trunk side upper trim (5 door)
11. C-pillar trim
12. Map light
13. Sunvisor
14. Assist handle
15. Headliner
16. Front door
17. Dashboard

2. Disconnect the front drain hose from the sunroof frame.
3. Remove the front drain hose from the clips.






4. Pull the front drain hose into the vehicle interior and remove the front drain hose.

FRONT DRAIN HOSE INSTALLATION

CAUTION: If the front drain hose is pinched or bent at any point, the water in the hose may not drain and could leak inside the vehicle. During and after installation of the trims and headliner, always make sure there is no interference with the front drain hose. Correct any abnormality if found.

1. Apply soapy water to the part of the sunroof frame where the front drain hose is inserted.
2. Insert the front drain hose end into the sunroof frame.
3. Install the front drain hose to the clips parallel to the pillar and free of looseness.
4. Insert the front drain hose grommet into the hole of the inner hinge pillar.
5. Install the following parts:
1. Dashboard
2. Front door
3. Headliner
4. Assist handle
5. Sunvisor
6. Map light
7. C-pillar trim
8. Trunk side upper trim (5 door)
9. Tire house trim
10. Rear seat
11. B-pillar upper trim
12. B-pillar lower trim
13. Rear scuff plate
14. Front scuff plate
15. Upper anchor of the front seat belt
16. A-pillar trim
17. Console (4 door)