Rear Drain Hose Removal/Installation

REAR DRAIN HOSE REMOVAL

1. Remove the following parts:
1. Console (4 door)
2. A-pillar trim
3. Upper anchor of the front seat belt
4. Front scuff plate
5. Rear scuff plate
6. B-pillar lower trim
7. B-pillar upper trim
8. Rear seat
9. Tire house trim
10. Trunk end trim
11. Trunk side upper trim (5 door)
12. Trunk side trim
13. C-pillar trim
14. Map light
15. Sunvisor
16. Assist handle
17. Headliner

2. Remove the sunroof frame from the rear drain hose.






3. Remove the rear drain hose from the clips.
4. Pull the rear drain hose into the vehicle interior 40001 and remove the rear drain hose.

REAR DRAIN HOSE INSTALLATION

CAUTION: If the rear drain hose is pinched or bent at any point, the water in the hose may not drain and could leak inside the vehicle. During and after installation of the trims and headliner, always make sure there is no interference with the rear drain hose. Correct any abnormality if found.

1. Apply soapy water to the part of the sunroof frame where the rear drain hose is inserted.
2. Insert the rear drain hose end into the sunroof frame.
3. Install the rear drain hose to the clips parallel to the pillar and free of looseness.
4. Insert the rear drain hose grommet into the hole of the inner rear pillar.
5. Install the following parts:
1. Headliner
2. Assist handle
3. Sunvisor
4. Map light
5. C-pillar trim
6. Trunk side trim
7. Trunk side upper trim (5 door)
8. Trunk end trim
9. Tire house trim
10. Rear seat
11. B-pillar upper trim
12. B-pillar lower trim
13. Rear scuff plate
14. Front scuff plate
15. Upper anchor of the front seat belt
16. A-pillar trim
17. Console (4 door)