Front Suspension

Stabilizer Shaft Link Replacement

Removal Procedure

Caution: Refer to Safety Glasses Caution (Safety Glasses Warning) .
Caution: Refer to Vehicle Lifting Caution (Service Precautions) .
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
2. Remove the front wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair) .





Important: Nuts with micro-encapsulated thread sealant must be discarded after removal.


3. Remove the stabiliser bar link to stabiliser bar retaining nut (1).
Discard the nut.
4. Disconnect the stabiliser bar link (2) from the stabiliser bar (3).




5. Remove the stabiliser bar link to strut assembly retaining nut (2).
Discard the nut.
6. Remove the stabiliser link bar (1) from the strut assembly bracket (3).
7. Inspect all parts for wear and damage.



Installation Procedure






Important: Install the shorter link end to the stabilizer bar.


1. Install the stabiliser bar link (2) to the stabiliser bar (3).
Notice: Refer to Fastener Notice (Fastener Notice) .
2. Install the NEW stabiliser bar link to stabiliser bar retaining nut (1).

Tighten the nut to 50 N.m (37 lb ft).






Important: Install the longer link end to the strut.


3. Install the stabiliser bar link (1) to the strut assembly bracket (3).
4. Install the NEW stabiliser bar link to strut assembly retaining nut (2).

Tighten the nut to 50 N.m (37 lb ft).

5. Install the front wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
6. Remove the safety stands.
7. Lower the vehicle to the ground.