Rear Propeller Shaft Coupling Replacement

Rear Propeller Shaft Coupling Replacement

Removal Procedure

Caution: Refer to Safety Glasses Caution (Safety Glasses Warning) .
Caution: Refer to Vehicle Lifting Caution (Service Precautions) .
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
2. Remove the propeller shaft from the vehicle. Refer to Propeller Shaft Replacement (Propeller Shaft Replacement) .





Important: Torque prevailing nuts with are single use parts and must be discarded after removal.


3. Remove the rubber coupling to propeller shaft retaining bolts (3) and torque prevailing nuts (4).
Discard the nuts.
4. Remove the rubber coupling (1) from the propeller shaft (2).



Installation Procedure






Important: The triangular mark (1) on the rubber coupling (2) must face towards the propeller shaft flange lug (3).


1. Install the rubber coupling (2) to the propeller shaft (4).

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the rubber coupling to propeller shaft retaining bolts (5) and NEW torque prevailing nuts (6).

Tighten the bolts and nuts to 20 N-m +55° (15 lb ft +55°).

3. Install the propeller shaft to the vehicle. Refer to Propeller Shaft Replacement (Propeller Shaft Replacement) .
4. Remove the safety stands.
5. Lower the vehicle to the ground.



Removal Procedure - Front Slip Joint

Caution: Refer to Safety Glasses Caution (Safety Glasses Warning) .
Caution: Refer to Vehicle Lifting Caution (Service Precautions) .
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
2. Remove the propeller shaft from the vehicle. Refer to Propeller Shaft Replacement (Propeller Shaft Replacement) .





Important: Torque prevailing nuts with are single use parts and must be discarded after removal.


3. Remove the rubber coupling to propeller shaft yoke retaining bolts (4) and torque prevailing nuts (3).
Discard the nuts.
4. Remove the propeller shaft yoke (1) from the rubber coupling (2).





Important: Torque prevailing nuts with are single use parts and must be discarded after removal.


5. Remove the rubber coupling to propeller shaft retaining bolts (3) and torque prevailing nuts (4).
Discard the nuts.
6. Remove the rubber coupling (1) from the propeller shaft (2).



Installation Procedure - Front Slip Joint






Important: The triangular mark (1) on the propeller shaft rubber coupling (2) must align with the propeller shaft flange lug (3).


1. Install the rubber coupling (2) to the propeller shaft (4).

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the rubber coupling to propeller shaft retaining bolts (5) and NEW torque prevailing nuts (6).

Tighten the bolts and nuts to 20 N-m +55° (15 lb ft +55°).





3. Install the propeller shaft yoke (1) to the rubber coupling (2).
4. Install the propeller shaft yoke to rubber coupling retaining bolts (4) and NEW torque prevailing nuts (3).

Tighten the bolts and nuts to 20 N-m +55° (15 lb ft +55°).

5. Install the propeller shaft to the vehicle. Refer to Propeller Shaft Replacement (Propeller Shaft Replacement) .
6. Remove the safety stands.
7. Lower the vehicle to the ground.