Drive Belt Tensioner: Service and Repair

Drive Belt Tensioner Replacement

Special Tools

J 45025 Torque Wrench Adapter

Removal Procedure




1. Remove the drive belt. Refer to Drive Belt Replacement (Service and Repair).
2. Remove the drive belt tensioner bolt.
3. Remove the drive belt tensioner.

Installation Procedure




1. Position the drive belt tensioner. Ensure that the tensioner is flush with the front cover.

Caution: Refer to Fastener Caution (Fastener Caution).

Note: In order to obtain the proper torque when using any torque wrench adapter you must use the following formula: Pre-set Torque = Torque Wrench Length x Torque Desired divided by Torque Wrench Length + Extension Length.

2. Install the drive belt tensioner bolt.
Using the J 45025 tighten the drive belt tensioner bolt.

Tighten the bolt to 45 Nm (33 lb ft).

3. Install the drive belt. Refer to Drive Belt Replacement (Service and Repair).