Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust

Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust

Removal Procedure

1. Turn the ignition OFF.




2. Remove the camshaft position (CMP) actuator valve electrical connector (1) from the CMP (2).




3. Remove the CMP actuator solenoid valve to engine front cover retaining bolt (1).
4. Remove the CMP actuator valve (2).
5. Inspect the CMP actuator valve seal and replace as necessary.

Installation Procedure

1. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.




2. Install the CMP actuator valve (2) to the engine front cover.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the CMP actuator solenoid valve to engine front cover retaining bolt (1) and tighten to 10 Nm (89 lb in).




4. Install the CMP valve electrical connector (1) to the CMP actuator valve.