Garage Door Opener Transmitter: Service and Repair

WM 967919 Removing and installing control unit for garage door opener

Preliminary work

Remove front apron. -> 631519 Removing and installing front apron - section on "Removing"

Removing control unit for garage door opener





Installation position of control unit for garage door opener

1. Switch off ignition and remove the remote control from the ignition lock.
2. Unlock locking mechanism -A- and slide control unit for garage door opener out of the bracket -B-.





Removing control unit

3. Release the plug connection -a- and pull it off.





Disconnecting plug connection

Installing control unit for garage door opener

1. Connect plug connection until it engages securely -arrow-.





Connecting plug connection

2. Slide control unit for garage door opener into the bracket -arrow-.





Sliding in control unit

3. Check that control unit for garage door opener is seated securely.

Subsequent work

Information

If the garage door opener was replaced, the remote controls (for the customer's garage door drives, for example) must be re-taught. -> 967955 Replacing control unit for garage door opener

Install front apron. -> 631519 Removing and installing front apron - section on "Installing"