Global Positioning System (GPS) Antenna Replacement (Module Assembly Radio Antenna)

Global Positioning System (GPS) Antenna Replacement (Module Assembly Radio Antenna)

Removal Procedure

Important: It is not necessary to lower the steering column to remove the radio antenna module.


1. Remove the navigational radio. Refer to Radio Replacement (Radio Replacement).




2. Disconnect the electrical connector from the navigational radio (1).
3. Partially remove the instrument panel (I/P) assembly from the I/P structure, to gain access to the antenna module retaining screw. Refer to Instrument Panel Assembly Replacement (Instrument Panel Assembly Replacement).
4. Remove the screw retaining the radio antenna module to the cross-car beam (2).
5. Remove the antenna module from the vehicle.

Installation Procedure




1. Install the antenna module to the vehicle.
2. Install the screw retaining the antenna module to the cross-car beam (2).

Notice: Refer to Fastener Notice (Fastener Notice).

3. Tighten the screw.

Tighten the screw to 2.5 Nm (22 in. lbs.).

4. Install the I/P assembly. Refer to Instrument Panel Assembly Replacement (Instrument Panel Assembly Replacement).
5. Connect the electrical connector to the navigational radio (1).
6. Install the navigational radio. Refer to Radio Replacement (Radio Replacement).