Front Bumper Upper Fascia Replacement

Front Bumper Upper Fascia Replacement










Preliminary Procedures

Notice:Refer to.

TipFiller close out panel is part of the fascia.
Tighten
TipThe screws are located across the bottom of the fascia extension.
Tighten
TipPull forward to release the extension from the upper retainers.

TipOne in each lower corner of the fascia.

TipThe fascia upper corners are retained by push snap retainers. Grabbing the inside corner of the fascia and pull forward to until fully released.

TipIt will be necessary to drill out the rivets that attach the bracket to the fascia.

TipIt will be necessary to drill out rivets that attach the upper fascia to the lower fascia.