P0705

DTC P0705

DTC Detecting Condition and Trouble Area






Circuit Diagram










DTC Confirmation Procedure

NOTE:

Check that the following condition is satisfied when using this procedure.

- Battery voltage > 10.5 V

1) Push engine switch to change ignition mode to "ON", and leave ignition mode in "ON" for 10 sec.

DTC Troubleshooting

1.
Was "CVT System Check" performed?
YES -
Go to Step 2.
NO -
Go to CVT System Check CVT System Check.

2. Transmission range sensor circuit check for operation using SUZUKI scan tool

Confirm that ignition mode of keyless push start system is in "OFF".
Connect SUZUKI scan tool to DLC.
Push engine switch to change ignition mode to "ON".
Check transmission range signal ("P", "R", "N", "D") on scan tool display when shifting select lever to each range.

Is applicable range indicated?
YES -
Go to Step 5.
NO -
Go to Step 3.

3. Select cable adjustment check

Check select cable for adjustment. Procedures

Is it adjusted correctly?
YES -
Go to Step 4.
NO -
Adjust select cable and recheck DTC.

4. Transmission range sensor adjustment check

Check transmission range sensor for adjustment. Adjustments

Is it adjusted correctly?
YES -
Go to Step 5.
NO -
Adjust transmission range sensor and recheck DTC.

5. Transmission range sensor circuit signal check

Push engine switch to change ignition mode to "OFF".
Disconnect "C166", "E19" and "E20" connectors.
Check for proper terminal connection to "C166", "E19" and "E20" connectors.
If connections are OK, check the following points.
- Resistance between each of "A1", "A2", "A3", "A4" and "A5" circuit terminals and each terminal at "C166" connector: infinity
- Voltage of "A1", "A2", "A3", "A4" and "A5" circuits: 0 - 1 V (with ignition mode of keyless push start system in "ON")

Are they in good condition?
YES -
Go to Step 6.
NO -
Repair or replace defective wire harness.

6. Transmission range sensor check

Check transmission range sensor. Transmission Range Sensor Inspection

Is it in good condition?
YES -
Substitute a known-good TCM and recheck DTC. Service and Repair
NO -
Replace transmission range sensor. Transmission Range Sensor Removal and Installation