Removal

ENGINE HOOD / DOOR: HOOD LOCK CONTROL CABLE ASSEMBLY:

COMPONENTS







ENGINE HOOD / DOOR: HOOD LOCK CONTROL CABLE ASSEMBLY:

REMOVAL

1. REMOVE FRONT WHEEL
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD





(a) Remove the 3 screws and the front wheel opening extension pad.
3. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE) (Removal)

4. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light) (Removal)

5. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light) (Removal)

6. REMOVE FRONT FENDER LINER





(a) Remove the 5 clips and bolt.
(b) Remove the 4 screws, grommet, and the front fender liner.
7. REMOVE HIGH PITCHED HORN ASSEMBLY (Removal)

8. REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)





(a) Remove the 3 bolts.





(b) Disconnect the hood lock control cable.
(c) Remove the hood lock assembly.
9. REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)





(a) Disconnect the connector.
(b) Remove the 3 bolts.





(c) Disconnect the hood lock control cable.
(d) Remove the hood lock assembly.
10. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY





(a) Disconnect the hood lock control cable and remove the hood lock control lever.
11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Using a screwdriver, disconnect the clamps shown in the illustration.









HINT: Tape the screwdriver tip before use.

(b) Pull the cable from the engine compartment and remove it.