Removal

EXTERIOR: REAR BUMPER:

COMPONENTS









REMOVAL

HINT:
- The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
- A bolt without a torque specification is shown in the standard bolt chart (Standard Bolt - Specified Torque For Standard Bolts).

1. REMOVE REAR FLOOR FINISH PLATE (Removal)

2. REMOVE REAR BUMPER ASSEMBLY





(a) Put protective tape under the quarter panel.
(b) Remove the 4 clips, 2 screws and 4 nuts.
(c) Using a screwdriver, disengage the 7 claws and remove the rear bumper.

HINT: Tape the screwdriver tip before use.

(d) Disconnect the 2 license plate connectors.