Installation

POWER STEERING: 3MZ-FE VANE PUMP:

INSTALLATION

1. INSTALL VANE PUMP ASSEMBLY
(a) Temporarily install the vane pump assembly with the 2 bolts.
2. INSTALL VANE PUMP V BELT
(a) Install the V belt (Installation).
(b) Adjust the V belt tension (Engine).

(a) Using a wrench (24 mm) to keep the pressure port union, connect the pressure feed tube assembly with the union bolt and a new gasket.
Torque: 52 Nm (525 kgf-cm, 38 ft-lbf)

NOTE: Make sure that the stopper of the pressure feed tube assembly touches the bracket front as shown in the illustration, then tighten the union bolt.

4. INSTALL POWER STEERING OIL PRESSURE SWITCH
(a) Install the oil pressure switch to the union bolt.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)

NOTE: Be careful to keep oil away from the connector.

(b) Connect the connector.
5. CONNECT OIL RESERVOIR TO PUMP HOSE NO.1
(a) Connect the oil reservoir to pump hose No.1.
(b) Install the clip.
6. INSTALL FRONT WHEEL RH
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
7. BLEED POWER STEERING FLUID (Power Steering System)

8. CHECK FOR FLUID LEAKS