Installation

SEAT: FRONT SEAT ASSEMBLY (for Power Seat): INSTALLATION

INSTALLATION

1. INSTALL FRONT SEAT ASSEMBLY
(a) Place the front seat assembly in the cabin.

NOTE: Be careful not to damage the vehicle body.

(b) Connect the connectors under the seat.
(c) Connect the cable to the negative (-) battery terminal.

NOTE: Some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization).

(d) Temporarily install the front seat assembly with the 4 bolts.
(e) Operate the power seat switch knob and move the seat to the rearmost position.





(f) Tighten the 2 bolts on the front side of the seat.
Torque: 37 Nm (377 kgf-cm, 27 ft-lbf)

HINT: Tighten the bolts in the order indicated in the illustration.

(g) Operate the power seat switch knob and move the seat to the foremost position.





(h) Tighten the 2 bolts on the rear side of the seat to install the front seat assembly.
Torque: 37 Nm (377 kgf-cm, 27 ft-lbf)

HINT: Tighten the bolts in the order indicated in the illustration.

2. INSTALL REAR INNER TRACK BRACKET COVER





(a) Engage the 2 claws to install the rear inner track bracket cover.
3. INSTALL REAR OUTER TRACK BRACKET COVER





(a) Engage the 2 claws to install the rear outer track bracket cover.
4. INSTALL FRONT INNER TRACK BRACKET COVER





(a) Engage the 2 claws to install the front inner track bracket cover.
5. INSTALL FRONT OUTER TRACK BRACKET COVER





(a) Engage the 2 claws to install the front outer track bracket cover.
6. INSTALL FRONT SEAT HEADREST ASSEMBLY
7. INSPECT POWER SEAT CONTROL SYSTEM
Inspect the power seat operation On-Vehicle Inspection.
8. INSPECT SEAT HEATER SYSTEM (w/ Seat Heater System)
Inspect the seat heater operation Seat Heater System.
9. INITIALIZE ZERO POINT CALIBRATION (for Front Passenger Seat)

HINT: If the occupant classification ECU has been replaced, perform zero point calibration and sensitivity check Programming and Relearning.

10. INSPECT SRS WARNING LIGHT
Inspect the SRS warning light Diagnosis System.