Installation

SUSPENSION: REAR STABILIZER BAR: INSTALLATION

INSTALLATION

1. INSTALL REAR STABILIZER BUSHING





(a) Install the 2 rear stabilizer bushings to the outside of the stopper ring on the stabilizer bar.
2. INSTALL REAR STABILIZER BAR NO. 2 BRACKET
(a) Install the rear stabilizer bar No. 2 bracket.
3. INSTALL REAR STABILIZER BAR NO. 1 BRACKET
(a) Install the rear stabilizer bar No. 1 bracket.
4. INSTALL REAR STABILIZER BAR





(a) Install the rear stabilizer bar with the 2 bolts. (LH Side)
Torque: 31 Nm (316 kgf-cm, 23ft-lbf)





(b) Install the rear stabilizer bar with the 2 bolts. (RH Side)
Torque: 31 Nm (316 kgf-cm, 23ft-lbf)
5. INSTALL REAR STABILIZER LINK ASSEMBLY LH





(a) Install the rear stabilizer link assembly LH with the 2 nuts.
Torque: 39 Nm (398 kgf-cm, 29ft-lbf)
HINT: If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.

6. INSTALL REAR STABILIZER LINK ASSEMBLY RH





(a) Install the rear stabilizer link assembly RH with the 2 nuts.
Torque: 39 Nm (398 kgf-cm, 29ft-lbf)
HINT: If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.

7. INSTALL CENTER EXHAUST PIPE ASSEMBLY (for 2AZ-FE) Installation
8. INSTALL CENTER EXHAUST PIPE ASSEMBLY (for 2GR-FE) Installation
9. INSTALL TAIL EXHAUST PIPE ASSEMBLY (for 2GR-FE) Installation
10. INSTALL REAR WHEELS
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)
11. INSPECT EXHAUST GAS LEAK Installation