Installation

E351 MANUAL TRANSAXLE: DIFFERENTIAL OIL SEAL: INSTALLATION

INSTALLATION

1. INSTALL FRONT TRANSAXLE CASE COVER OIL SEAL





(a) Coat a new oil seal lip with MP grease.
(b) Using SST and a hammer, install the oil seal.
SST: 09608-10010
SST: 09950-70010
09951-07200
Installation depth:
-0.5 to 0.5 mm (-0.020 to 0.020 in.)
NOTICE: Be careful not to damage the oil seal lip.

2. INSTALL TRANSAXLE CASE OIL SEAL





(a) Coat a new oil seal lip with MP grease.
(b) Using SST and a hammer, install the oil seal.
SST: 09608-32010
SST: 09950-70010
09951-07200
Installation depth:
3.0 to 4.0 mm (0.1181 to 0.1575 in.)
NOTICE: Be careful not to damage the oil seal lip.

3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
TMC made: Installation.
TMMK made: Installation.
4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
HINT: Use the same procedures described for the LH side.

5. INSTALL FRONT WHEELS
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)
6. ADD MANUAL TRANSAXLE OIL





(a) Park the vehicle on a level place.
(b) Remove the filler plug and gasket.
(c) Check that the oil surface is within 5 mm (0.20 in.) below the lowest point of the filler plug opening.
Oil grade:
API GL-4 or GL-5
Viscosity:
SAE 75W-90
NOTICE:
- Problems may occur if the oil level is too high or too low.
- After replacing the oil, drive the vehicle and check the oil level again.

(d) Check for oil leakage if the oil level is low.
(e) Install the filler plug and a new gasket.
Torque: 49 Nm (500 kgf-cm, 36ft-lbf)
7. INSPECT MANUAL TRANSAXLE OIL Testing and Inspection
8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT Service and Repair.
9. CHECK ABS SPEED SENSOR SIGNAL
(a) ABS: Test Mode Procedure.
(b) VSC (for BOSCH): Test Mode Procedure.
(c) VSC (for ADVICS): Test Mode Procedure.