Radio Broadcast Cannot be Received or Poor Reception

NAVIGATION: NAVIGATION SYSTEM: Radio Broadcast cannot be Received or Poor Reception

Radio Broadcast cannot be Received or Poor Reception

INSPECTION PROCEDURE

PROCEDURE

1. CHECK NAVIGATION RECEIVER ASSEMBLY
(a) Check the radio's automatic station search function.
(1) Check the radio's automatic station search function by activating it.
OK:
The radio's automatic station search function works properly.
OK -- REPLACE NAVIGATION RECEIVER ASSEMBLY
NG -- Continue to next step.
2. INSPECT NAVIGATION RECEIVER ASSEMBLY




(a) Disconnect the navigation receiver assembly connector F9.
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:






NG -- REPLACE NAVIGATION RECEIVER ASSEMBLY
OK -- Continue to next step.
3. CHECK OPTIONAL COMPONENTS
(a) Check optional components (sunshade film, telephone antenna, etc.).
(1) Check if any optional components, such as sunshade film or telephone antenna that may decrease reception capacity, are installed.
OK:
Optional components are installed.
NOTICE: Do not remove any optional components installed by the customer without his or her consent.

OK -- REMOVE AND RECHECK OPTIONAL COMPONENTS (SEE NOTICE ABOVE)
NG -- Continue to next step.
4. CHECK NAVIGATION RECEIVER ASSEMBLY




(a) Preparation for check
(1) Remove the antenna plug from the navigation receiver assembly.
(b) Check for noise.
(1) Power switch on (ACC) with the navigation receiver assembly connector connected.
(2) Turn the radio on and put into AM mode.
(3) Place a screwdriver, thin wire, or other metal object on the radio receiver's antenna jack and check that noise can be heard from the speaker.
OK:
Noise occurs.
NG -- REPLACE NAVIGATION RECEIVER ASSEMBLY
OK -- Continue to next step.
5. CHECK GLASS ANTENNA




(a) Check for continuity of the antenna.
HINT: Check for continuity at the center of each antenna wire as shown in the illustration.
NOTICE: When cleaning the glass, wipe it in the direction of the wire with a soft dry cloth. Take care not to damage the wire. Do not use detergents or glass cleaners with abrasive ingredients. When measuring voltage, wrap a piece of tin foil around the tip of the negative probe and press the foil against the wire with your finger, as shown in the illustration.

OK:
There is continuity in the antenna.
NG -- REPAIR GLASS ANTENNA
OK -- Continue to next step.
6. REPLACE ANTENNA AMPLIFIER
(a) Replace the antenna amplifier and check that it operates normally.
OK:
The antenna amplifier operates normally.
OK -- END
NG -- REPLACE NAVIGATION RECEIVER ASSEMBLY