Removal

METER: COMBINATION METER: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment Service Precautions.

2. REMOVE FRONT DOOR SCUFF PLATE LH Removal
3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal
4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH





(a) Remove the screw and the bolt.
(b) Disconnect the hood lock control cable assembly.
(c) Disengage the claw and the 9 clips.
(d) Remove the air hose, disconnect each connector, and then remove the lower instrument panel finish panel LH.
5. REMOVE STEERING COLUMN COVER





(a) Turn the steering wheel assembly to the right and remove the screw as shown in the illustration.





(b) Turn the steering wheel assembly to the left and remove the screw as shown in the illustration.





(c) Disengage the 2 claws and remove the steering column cover lower.





(d) Disengage the claw and remove the steering column cover upper.
6. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for TMC Made) Removal
7. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for TMMK Made) Removal
8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for TMC Made) Removal
9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for TMMK Made) Removal
10. REMOVE INSTRUMENT CLUSTER FINISH PANEL





(a) Remove the 2 clips.
(b) Disengage the guide and the 4 claws, and then remove the instrument cluster finish panel.
11. REMOVE COMBINATION METER ASSEMBLY
(a) Using the tilt and telescopic functions, fully lower and extend the steering wheel.





(b) Remove the 4 screws.





(c) Disconnect the 2 connectors.
(d) Disengage the wire harness from the combination meter assembly.





(e) Remove the combination meter assembly as shown in the illustration.