Installation

SUPPLEMENTAL RESTRAINT SYSTEM: DRIVER SIDE KNEE AIRBAG ASSEMBLY (for TMMK Made): INSTALLATION

INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
(a) Check that the power switch is turned off.
(b) Check that the battery negative (-) cable is disconnected.
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.





(c) Temporarily install the driver side knee airbag assembly with the 2 hooks.
(d) Engage the 2 claws and install the DLC3.





(e) Install the driver side knee airbag assembly with the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7ft-lbf)
(f) Connect the driver side knee airbag connector.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH Installation
3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
4. INSTALL FRONT DOOR SCUFF PLATE LH Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTICE: Some systems need initialization after reconnecting the cable to the negative battery terminal.

7. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.